Arduino Clone Breadboard Kit (328)
If you've used the Arduino for a little while and you really want to dig a little deeper into how the Arduino really
works then this kit is a great stepping stone!. This kit allows you to
build 100% compatible Arduino straight on your own breadboard! Each of
the AtMega 328's are pre-loaded with the Arduino NG bootloader and the
blink sketch. Each kit is entirely new and tested.
What's in the kit?**
Atmel AtMega 328 MCU - Preprogrammed with 'Arduino NG'
2 low power LEDs (colours may vary but usually 1xgreen 1xred)
1x 16Mhz Crystal
3x 1k ohm resisters (A little higher than needed but better to be safe!)
2x 10uf capacitors*
1x 5 volt voltage regulator
2x 22pf capacitors
* Dependant on stock you may be provided with 47uf capacitors. If you'd prefer to have one or the other please let me know.
** Components are subject to change dependent on stock, if you have special requirements please contact me.
We can supply hookup wire if required. Please note: The breadboard
isn't included (in this particular kit), if you'd like one included
please contact me for a quote.
Building your kit
One of the best guides for building your breadboard kit is available here: New York University.
Take a look through and make sure you feel confident building your very
own Arduino. Don't forget you'll need something to program your new
BoardDuino, if you've already got an Arduino you can use the FTDI ports
(Arduino ports 0 and 1) as described by the talented TodBot otherwise we suggest the FTDI cable from Farnell or if you're willing to wait a little longer, the 5 Volt FTDI adapter from SparkFun (USA)
This product was added to our catalog on Monday 08 March, 2010.
